Use the CPU08 to power your next robot or control solution. You can get started with a complete development solution for less than $200 including an IDE development and programming environment.
The CPU08 is a small inexpensive single board computer (SBC) based on the Motorola 68HC908GP32 micro controller with 32K of flash memory. This SBC is oriented toward education and embedded control. Since the SBC is flash based you only need a simple serial adaptor to program it from any PC and development tools are readily available.
Based on Motorola 68HC908GP32 micro controller
32K Flash Memory
512 bytes RAM
9.8304 MHz Crystal
8 Channel / 8 bit ADC
In Circuit Programmable
1 Full Duplex UART w/EIA-232 Level Converter
1 SPI
2 - 16 bit counter/timers with Input Capture, Output Compare, and PWM mode
33 General Purpose IO - 26 shared, 7 dedicated
bit selectable pullups on Ports A, C, and D pins
10ma sink/source on all port pins
15ma on port C bits 0 to 4
8x8 Multiply and 16/8 divide instruction
BCD instructions
C language friendly
PCB Dimensions: 2.5" (63.5mm) x 2.4" (61mm)
40 PIN .1" Dual Row Header for CPU Connections (Allows Use of Standard IDE Ribbon Cable to connect to application circuits)
10 PIN .1" Dual Row Header for Programming
PROG08 PC Programming Adaptor Available from Centric or use Motorola M68SPGMR08 Programmer Base
Centric Prog08
Use Motorola M68SPGMR08 or with adaptor cable
Purchase Securely using 
[Home] [CPU08] [Prog08] [Demo08] [CPU08Kit] [Product Order Page] [CONTACT]